Cisco Sx350 User Manual

DHCPv6 Commands
359 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
14
switchxxxxxx(config-if)# exit
Example 5. The following example disables DHCPv6 relay on VLAN 100:
switchxxxxxx(config)# interface vlan 100
switchxxxxxx(config-if)# no ipv6 dhcp relay destination
switchxxxxxx(config-if)# exit
14.8 show ipv6 dhcp
To display the Dynamic DHCP unique identifier (DUID) on a specified device, use
the show ipv6 dhcp command in User EXEC mode.This information is relevant for
DHCPv6 clients and DHCPv6 relays.
Syntax
show ipv6 dhcp
Parameters
NA
Command Mode
User EXEC mode
User Guidelines
This command uses the DUID, which is based on the link-layer address for both
client and server identifiers. The device uses the MAC address from the
lowest-numbered interface to form the DUID.
Examples
Example 1. The following is sample output from this command when the switch’s
DUID format is vendor based on enterprise number:
switchxxxxxx# show ipv6 dhcp
The switch’s DHCPv6 unique identifier(DUID)is 0002000000090CC084D303000912

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English