Cisco Sx350 - Cdp Mandatory-Tlvs Validation

CDP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 214
8
Interface (Ethernet) Configuration mode. To disable the generation of the SYSLOG
messages, use the no format of the CLI command.
Syntax
cdp log mismatch voip
no cdp log mismatch voip
Parameters
N/A
Default Configuration
The switch reports VoIP mismatches from all ports.
Command Mode
Global Configuration mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# cdp log mismatch voip
8.9 cdp mandatory-tlvs validation
To validate that all mandatory (according to the CDP protocol) TLVs are present in
received CDP frames, use the cdp mandatory-tlvs validation command in Global
Configuration mode. To disables the validation, use the no form of this command.
Syntax
cdp mandatory-tlvs validation
no cdp mandatory-tlvs validation
Parameters
N/A