Cisco Sx350

Ethernet Configuration Commands
401 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
17
17.20 show interfaces status
To display the status of all interfaces or of a specific interface, use the show
interfaces status Privileged EXEC mode command.
Syntax
show interfaces status
[interface-id | detailed ]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Command Mode
Privileged EXEC mode
Default Configuration
Display for all interfaces. If detailed is not used, only present ports are displayed.
Example
The following example displays the status of all configured interfaces.
switchxxxxxx# show interfaces status
Flow Link Back Mdix
Port Type Duplex Speed Neg ctrl State Pressure Mode
------ --------- ------ ----- -------- ---- ------ -------- --
gi11 1G-Copper Full 1000 Disabled Off Up Disabled Off
Legend
Neg: Negotiation
Flow Cont: Flow Control