Cisco Sx350

Ethernet Configuration Commands
387 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
17
Syntax
description
string
no description
Parameters
string—Specifies a comment or a description of the port to assist the user.
(Length: 1–64 characters).
Default Configuration
The interface does not have a description.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example adds the description ‘SW#3’ to gi14.
switchxxxxxx(config)# interface gi14
switchxxxxxx(config-if)# description SW#3
17.6 speed
To configure the speed of a given Ethernet interface when not using
auto-negotiation, use the speed Interface (Ethernet, Port Channel) Configuration
mode command. To restore the default configuration, use the no form of this
command.
Syntax
speed {10
| 100 | 1000 }
no speed
Parameters
• 10—Forces10 Mbps operation
• 100—Forces 100 Mbps operation