Cisco Sx350

Address Table Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 128
4
You can execute the command before the VLAN is created.
Examples
Example 1 - The following example registers the MAC address to the bridge table:
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast address 01:00:5e:02:02:03
Example 2 - The following example registers the MAC address and adds ports
statically.
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast address 01:00:5e:02:02:03 add
gi11-2
4.4 bridge multicast forbidden address
To forbid adding or removing a specific Multicast address to or from specific ports,
use the bridge multicast forbidden address IInterface (VLAN) Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
bridge multicast forbidden address {
mac-multicast-address |
ipv4-multicast-address
} {add | remove} {ethernet interface-list | port-channel
port-channel-list
}
no bridge multicast forbidden address
mac-multicast-address
Parameters
• mac-multicast-address | ipv4-multicast-address—Specifies the group
Multicast address.
• add—Forbids adding ports to the group.
• remove—Forbids removing ports from the group.