Cisco Sx350

Radius Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 982
49
Syntax
radius server group
group-name
no radius server group [ group-name ]
Parameters
• group-name —Specifies a name of the group. (Length: 1–32 characters)
Default Configuration
The group does not exist.
Command Mode
Global Configuration mode
User Guidelines
Use the radius server group command, to enter into the Radius Server Group
Configuration mode. If this group does not exist it is created automatically.
Use the no radius server group
group-name command, to delete one group.
Use the no radius server group command, to delete all groups.
A group cannot be deleted, if there is a user referencing to this group.
The Radius server supports up to 50 groups.
Example
The following example creates group developers, if it does not exist, and enters
into its context:
switchxxxxxx(config)# radius server group developers
switchxxxxxx(config-radser-group)#
49.10 radius server nas secret
To create a secret key, use the radius server nas secret key command in Global
Configuration mode. To delete the key, use the no form of this command.