Cisco Sx350 User Manual

IPv6 First Hop Security
667 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
29
Example 4—In the following example, Neighbor Binding Integrity detaches policy
policy1 detached to the gi11 port:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# no ipv6 neighbor binding attach-policy policy1
switchxxxxxx(config-if)# exit
29.43 ipv6 neighbor binding attach-policy
(VLAN mode)
To attach a Neighbor Binding policy to a specific VLAN, use the ipv6 neighbor
binding attach-policy command in VLAN Configuration mode. To return to the
default, use the no form of this command.
Syntax
ipv6 neighbor binding attach-policy
policy-name
no ipv6 neighbor binding attach-policy
Parameters
• policy-name —The Neighbor Binding policy name (up to 32 characters).
Default Configuration
The Neighbor Binding default policy is applied.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use this command to attach a Neighbor Binding policy to a VLAN.
If a policy specified by the
policy-name argument is not defined, the command is
rejected.
Use the no form of the command to return to detach the current policy and
reattach the default policy. The no form of the command has no effect if the default
policy was attached.

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English