Cisco Sx350

IGMP Snooping Commands
497 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
23
no ip igmp snooping vlan vlan-id immediate-leave
Parameters
• vlan-id —Specifies the VLAN ID value. (Range: 1–4094).
Default Configuration
Disabled
Command Mode
Global Configuration mode
User Guidelines
You can execute the command before the VLAN is created.
Example
The following example enables IGMP snooping immediate-leave feature on VLAN
1.
switchxxxxxx(config)# ip igmp snooping vlan 1 immediate-leave
23.15 show ip igmp snooping cpe vlans
To display the CPE VLAN to Multicast TV VLAN mappings, use the show ip igmp
snooping cpe vlans command in User EXEC mode.
Syntax
show ip igmp snooping cpe vlans [vlan
vlan-id ]
Parameters
• vlan vlan-id —(Optional) Specifies the CPE VLAN ID.
Command Mode
User EXEC mode