Cisco Sx350

SSH Client Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1148
59
Syntax
ip ssh-client source-interface
interface-id
no ip ssh-client source-interface
Parameters
• interface-id —Specifies the source interface.
Default Configuration
The source IPv4 address is the IPv4 address defined on the outgoing interface
and belonging to next hop IPv4 subnet.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface then the interface IP address
belonging to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface then the minimal IPv4 address
defined on the source interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to communicate with an IPv4 SSH servers.
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)# ip ssh-client source-interface vlan 100
59.8 ipv6 ssh-client source-interface
To specify the source interface whose IPv6 address will be used as the Source
IPv6 address for communication with IPv6 SSH servers, use the ipv6 ssh-client
source-interface Global Configuration mode command. To restore the default
configuration, use the no form of this command.