Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
789 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
36
Port Capabilities Network Policy Location Notifications Inventory
------ -------------- -------------- ---------- ------------- --------
gi11 Yes Yes Yes Enabled Yes
gi12 Yes Yes No Enabled No
gi13 No No No Enabled No
Example 2 - The following example displays the LLDP MED configuration for gi1 1.
switchxxxxxx# show lldp med configuration gi11
Port Capabilities Network Policy Location Notifications Inventory
------- -------------- ---------------- --------- ---------- --------
gi11 Yes Yes Yes Enabled Yes
Network policies:
Location:
Civic-address: 61:62:63:64:65:66
36.27 show lldp neighbors
To display information about neighboring devices discovered using LLDP, use the
show lldp neighbors Privileged EXEC mode command. The information can be
displayed for all ports or for a specific port.
Syntax
show lldp neighbors
[interface-id]
Parameters
interface-id—(Optional) Specifies a port ID.
Default Configuration
If no port ID is entered, the command displays information for all ports.
Command Mode
Privileged EXEC mode