Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 774
36
Default Configuration
Disabled.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables sending LLDP notifications on gi11.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# lldp notifications enable
36.14 lldp notifications interval
To configure the maximum transmission rate of LLDP notifications, use the lldp
notifications interval Global Configuration mode command. To return to the default,
use the no form of this command.
Syntax
lldp notifications interval
seconds
no lldp notifications interval
Parameters
interval
seconds —The device does not send more than a single notification in the
indicated period (range: 5–3600).
Default Configuration
5 seconds
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# lldp notifications interval 10