Cisco Sx350

Link Aggregation Control Protocol (LACP) Commands
757 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
35
• short—Specifies the short timeout value.
Default Configuration
The default port timeout value is Long.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example assigns a long administrative LACP timeout to
gi1 6.
switchxxxxxx(config)# interface gi16
switchxxxxxx(config-if)# lacp timeout long
35.4 show lacp
To display LACP information for all Ethernet ports or for a specific Ethernet port,
use the show lacp Privileged EXEC mode command.
Syntax
show lacp
interface-id [parameters | statistics | protocol-state ]
Parameters
• interface-id—Specify an interface ID. The interface ID must be an Ethernet
port
• parameters—(Optional) Displays parameters only.
• statistics—(Optional) Displays statistics only.
• protocol-state—(Optional) Displays protocol state only.
Command Mode
Privileged EXEC mode