CDP Commands
223 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
8
Syntax
show cdp interface
interface-id
Parameters
interface-id—Port ID.
Command Mode
Privileged EXEC mode
Example
switchxxxxxx#
show cdp interface
gi11
CDP is globally enabled
CDP log duplex mismatch
Globally is enabled
Per interface is enabled
CDP log voice VLAN mismatch
Globally is enabled
Per interface is enabled
CDP log native VLAN mismatch
Globally is disabled
Per interface is enabled
gi11 is Down, CDP is enabled
Sending CDP packets every 60 seconds
Holdtime is 180 seconds
8.19 show cdp neighbors
To display information about neighbors kept in the main or secondary cache, use
the show cdp neighbors command in Privileged EXEC mode.
Syntax
show cdp neighbors [
interface-id
] [detail | secondary]
Parameters
• interface-id—Displays the neighbors attached to this port.
To Next Page
Loading...
