Cisco Sx350

CDP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 224
8
• detail—Displays detailed information about a neighbor (or neighbors) from
the main cache including network address, enabled protocols, hold time,
and software version.
• secondary—Displays information about neighbors from the secondary
cache.
Default Configuration
If an interface ID is not specified, the command displays information for the
neighbors of all ports.
If detail or secondary are not specified, the default is secondary.
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,P - VoIP Phone,
M - Remotely-Managed Device, C - CAST Phone Port, W - Two-Port MAC Relay
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - VoIP Phone
M - Remotely-Managed Device, C - CAST Phone Port,
W - Two-Port MAC Relay
Device ID Local Adv Time To Capability Platform Port ID
Interface Ver. Live
------------------ ----------- ---- ------- ---------- ------------ -----------
PTK-SW-A-86.company gi48 2 147 S I Company gi3/39
l.com XX-10R-E
ESW-520-8P gi48 2 153 S I M ESW-520-8P g1
ESW-540-8P gi48 2 146 S I M ESW-540-8P g9
003106131611 gi48 2 143 S I Company fa2/1
XX-23R-E
001828100211 gi48 2 173 S I Company fa2/2
XX-23R-E
c47d4fed9302 gi48 2 137 S I Company fa2/5
XX-23R-E
switchxxxxxx# show cdp neighbors detail