Cisco Sx350 - 1 Introduction

1
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 26
Introduction
This section describes how to use the Command Line Interface (CLI). It contains
the following topics:
• Overview
• User (Privilege) Levels
• CLI Command Modes
• Accessing the CLI
• CLI Command Conventions
• Editing Features
• Interface Naming Conventions
• IPv6z Address Conventions
• Loopback Interface
• PHY Diagnostics
• CLI Output Modifiers
Overview
The CLI is divided into various command modes. Each mode includes a group of
commands. These modes are described in CLI Command Modes.
Users are assigned privilege levels. Each user privilege level can access specific
CLI modes. User levels are described in the section below.