Cisco Sx350

Introduction
41 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
1
• Two IPv4 interfaces can be configured: one on a VLAN and one on the
loopback interface.
• If the IPv4 address was configured on the default VLAN and the default
VLAN is changed, the switch moves the IPv4 address to the new default
VLAN.
• The ip address command does the following:
- In VLAN context, it replaces the existing configured IPv4 address on the
specified interface by the new one.
- In Loopback Interface context, it replaces the existing, configured IPv4
address on the loopback interface with the new one.
- In the Loopback Interface context, it does not support the keyword
default-gateway.
PHY Diagnostics
The following exceptions exist:
• Copper Ports—PHY diagnostics are only supported on copper ports.
• 10G ports—TDR test is supported when the operational port speed is 10G.
Cable length resolution is 20 meters.
CLI Output Modifiers
To all show and more commands (except show technical support) an output
modifier may be added as follows:
<show/more command> | <output-modifier> <regular-expression-pattern>
The output modifiers are:
• begin: Start output from the first line that has a sequence of characters
matching the given regular expression pattern
• include: Includes only lines that have a sequence of characters matching the
given regular expression pattern.