Cisco Sx350

Auto-Update and Auto-Configuration
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 198
6
• extension —The SCP file extension. When no value is specified, 'scp' is used.
(Range: 1-16 characters)
Default Configuration
Enabled by default with the auto option.
Command Mode
Global Configuration mode
User Guidelines
The TFTP or SCP protocol is used to download/upload an image file.
Examples
Example 1—The following example specifies the auto mode and specifies "scon"
as the SCP extension:
switchxxxxxx(config)# boot host auto-update auto scon
Example 2—The following example specifies the auto mode and does not provide
an SCP extension. In this case "scp" is used.
switchxxxxxx(config)# boot host auto-update auto
Example 3—The following example specifies that only the SCP protocol will be
used:
switchxxxxxx(config)# boot host auto-update scp
6.3 show boot
Use the show boot Privilege EXEC mode command to show the status of the IP
DHCP Auto Config process.
Syntax
show boot