Cisco Sx350

Address Table Commands
147 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
4.19 mac address-table static
To add a MAC-layer station source address to the MAC address table, use the mac
address-table static Global Configuration mode command. To delete the MAC
address, use the no form of this command.
Syntax
mac address-table static
mac-address vlan vlan-id interface interface-id
[permanent
| delete-on-reset | delete-on-timeout | secure]|
no mac address-table static [
mac-address] vlan vlan-id
Parameters
• mac-address —MAC address (Range: Valid MAC address)
• vlan-id — Specify the VLAN
• interface-id —Specify an interface ID. The interface ID can be one of the
following types: Ethernet port or port-channel (Range: valid ethernet port,
valid port-channel)
• permanent—(Optional) The permanent static MAC address. The keyword is
applied by the default.
• delete-on-reset—(Optional)The delete-on-reset static MAC address.
• delete-on-timeout—(Optional)The delete-on-timeout static MAC address.
• secure—(Optional)The secure MAC address. May be used only in a secure
mode.
Console # show bridge unicast unknown
Port Unregistered
-------- ---------------------
gi11 Forward
gi12 Filter
gi13 Filter