Cisco Sx350

Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 922
47
User Guidelines
This command is available only when the device is in QoS advanced mode.
Command Mode
Class-map Configuration mode.
Example
The following example defines a class map called Class1. Class1 contains an ACL
called enterprise. Only traffic matching all criteria in enterprise belong to the class
map.
switchxxxxxx(config)# class-map class1
switchxxxxxx(config-cmap)# match access-group enterprise
47.7 policy-map
Use the policy-map Global Configuration mode command to creates a policy map
and enter the Policy-map Configuration mode. Use the no form of this command to
delete a policy map.
Syntax
policy-map
policy-map-name
no policy-map policy-map-name
Parameters
policy-map-name—Specifies the policy map name. (Length: 1–32 characters)
Default Configuration
N/A
Command Mode
Global Configuration mode
User Guidelines
This command is only available when QoS is in advanced mode.