Cisco Sx350

46
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 913
Port Channel Commands
1
46.1 channel-group
To associate a port with a port-channel, use the channel-group Interface (Ethernet)
Configuration mode command. To remove a port from a port-channel, use the no
form of this command.
Syntax
channel-group
port-channel mode {on | auto}
no channel-group
Parameters
• port-channel —Specifies the port channel number for the current port to
join.
• mode—Specifies the mode of joining the port channel. The possible values
are:
- on—Forces the port to join a channel without an LACP operation.
- auto—Forces the port to join a channel as a result of an LACP operation.
Default Configuration
The port is not assigned to a port-channel.
Command Mode
Interface (Ethernet) Configuration mode
Default mode is on.
User Guidelines
LACP starts to manage port joining.