Cisco Sx350

47
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 916
Quality of Service (QoS) Commands
47.0
47.1 qos
Use the qos Global Configuration mode command to enable QoS on the device
and set its mode. Use the no form of this command to disable QoS on the device.
Syntax
qos [basic | {advanced [ports-not-trusted | ports-trusted]}]
no qos
Parameters
• basic—QoS basic mode. If no option is specified, the QoS mode defaults to
the basic mode.
• advanced—Specifies the QoS advanced mode, which enables the full
range of QoS configuration.
• ports-not-trusted—Relevant for advanced mode only. Indicates that
packets, which are not classified by policy map rules to a QoS action, are
mapped to egress queue 0. This is the default setting in advanced mode.
• ports-trusted—Relevant for advanced mode only. Indicates that packets,
which are not classified by policy map rules to a QoS action, are mapped to
an egress queue based on the packet's fields. Use the qos advanced-mode
trust command to specify the trust mode.
Default Configuration
QoS basic mode
Command Mode
Global Configuration mode