Cisco Sx350

DHCP Snooping Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 324
13
Parameters
N/A
Default Configuration
DHCP packets with option-82 information from an untrusted port are discarded.
Command Mode
Global Configuration mode
Example
The following example allows a device to accept DHCP packets with option-82
information from an untrusted port.
switchxxxxxx(config)# ip dhcp snooping information option allowed-untrusted
13.5 ip dhcp snooping verify
Use the ip dhcp snooping verify Global Configuration mode command to
configure a device to verify that the source MAC address in a DHCP packet
received on an untrusted port matches the client hardware address. Use the no
form of this command to disable MAC address verification in a DHCP packet
received on an untrusted port.
Syntax
ip dhcp snooping verify
no ip dhcp snooping verify
Default Configuration
The switch verifies that the source MAC address in a DHCP packet received on an
untrusted port matches the client hardware address in the packet.
Command Mode
Global Configuration mode