Cisco Sx350

Radius Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 986
49
Example
The following example enables sending traps when authentication fails:
switchxxxxxx(config)# radius server traps authentication failure
49.13 radius server traps authentication
success
To enable sending traps when a user is successfully authorized, use the radius
server traps authentication success command in Global Configuration mode. To
disable the traps, use the no form of this command.
Syntax
radius server traps authentication success
no radius server traps authentication success
Parameters
N/A
Default Configuration
Success traps are disabled.
Command Mode
Global Configuration mode
User Guidelines
A rate limit is applied to the traps: not more than one trap of this type can be sent in 10
seconds.
Example
The following example enables sending traps when a user is successfully
authorized:
switchxxxxxx(config)# radius server traps authentication success