Cisco Sx350

Address Table Commands
137 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
switchxxxxxx(config-if)# bridge multicast ipv6 mode
ip-group
4.10 bridge multicast ipv6 ip-address
To register an IPv6 Multicast address to the bridge table, and statically add or
remove ports to or from the group, use the bridge multicast ipv6 ip-address
Interface (VLAN) Configuration mode command. To unregister the IPv6 address,
use the no form of this command.
Syntax
bridge multicast ipv6 ip-address
ipv6-multicast-address [[add | remove] {ethernet
interface-list |
port-channel port-channel-list }]
no bridge multicast ipv6 ip-address ip-multicast-address
Parameters
• ipv6-multicast-address—Specifies the group IPv6 multicast address.
• add—(Optional) Adds ports to the group.
• remove—(Optional) Removes ports from the group.
• ethernet interface-list —(Optional) Specifies a list of Ethernet ports.
Separate nonconsecutive Ethernet ports with a comma and no spaces; use
a hyphen to designate a range of ports.
• port-channel port-channel-list —(Optional) Specifies a list of port channels.
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode