Cisco Sx350

IPv6 IPM Router Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 722
30
switchxxxxxx(config-if)# exit
30.3 show ipv6 mroute
To display the contents of the Multicast routing (mroute) table, use the show ipv6
mroute command in user EXEC or privileged EXEC mode.
Syntax
show ipv6 mroute [ group-address [ source-address ]] [summary]
Parameters
• group-address —Destination Multicast IPv6 address.
• source-address —Source IPv6 address.
• summary—Filters the output to display a one-line, abbreviated summary of
each entry in the mroute table.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
Use the show ip mroute command to display information about Mroute entries in
the mroute table. The switch populates the Multicast routing table by creating (S,
G) entries from (*, G) entries. The asterisk (*) refers to all source addresses, the “S”
refers to a single source address, and the “G” is the destination Multicast group
address. In creating (S, G) entries, the switch uses the best path to that destination
group found in the Unicast routing table (that is, through Reverse Path Forwarding
[RPF]).
Examples
Description of Significant fields in the examples below
Timers:Uptime/Expires—“Uptime” indicates per interface how long (in hours,
minutes, and seconds) the entry has been in the IPv6 Multicast routing table.
“Expires” indicates per interface how long (in hours, minutes, and seconds) until
the entry will be removed from the IPv6 Multicast routing table.