Cisco Sx350

IPv6 IPM Router Commands
723 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
30
(*, FF07::1) and (FF07::1/128, FF07::1)—Entry in the IPv6 Multicast routing table. The
entry consists of the IP address of the source router followed by the IP address of
the Multicast group. An asterisk (*) in place of the source router indicates all
sources.
Entries in the first format are referred to as (*, G) or “star comma G” entries. Entries
in the second format are referred to as (S, G) or “S comma G” entries. (*, G) entries
are used to build (S, G) entries.
Incoming interface: —Expected interface for a Multicast packet from the source. If
the packet is not received on this interface, it is discarded.
Outgoing Interface List (OIF):—Interfaces through which packets will be forwarded.
Example 1. The following is sample output from the show ipv6 mroute command
with the summary keyword:
switchxxxxxx# show ip mroute summary
Timers: Uptime/Expires
IPv6 Multicast Routing Table
(2001:0DB8:999::99, FF07::5), 00:04:55/00:02:36, OIF count:1
(2001:0DB8:999::99, FF07::1), 00:02:46/00:00:12 , OIF count:1
Example 2. The following is sample output from the show ipv6 mroute command:
switchxxxxxx# show ip mroute
Timers: Uptime/Expires
IPv6 Multicast Routing Table
(*, FF07::1), 00:04:45/00:02:47, RP 2001:0DB8:6::6
Incoming interface: vlan5
Outgoing interface list:
vlan40, 00:04:45/00:02:47