Cisco Sx350

CDP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 212
8
Default Configuration
180 seconds.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# cdp holdtime 100
8.6 cdp log mismatch duplex
To enable validating that the duplex status of a port received in a CDP packet
matches the ports actual configuration and generation the SYSLOG duplex
mismatch messages if they do not match, use the cdp log mismatch duplex
command in Global Configuration mode and Interface (Ethernet) Configuration
mode. To disable the generation of the SYSLOG messages, use the no form of the
CLI command.
Syntax
cdp log mismatch duplex
no cdp log mismatch duplex
Parameters
N/A
Default Configuration
The switch reports duplex mismatches from all ports.
Command Mode
Global Configuration mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)# interface gi11