Cisco Sx350

11
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 281
DHCP Relay Commands
11.0
11.1 ip dhcp relay enable (Global)
Use the ip dhcp relay enable Global Configuration mode command to enable the
DHCP relay feature on the device. Use the no form of this command to disable the
DHCP relay feature.
Syntax
ip dhcp relay enable
no ip dhcp relay enable
Parameters
N/A
Default Configuration
DHCP relay feature is disabled.
Command Mode
Global Configuration mode
Example
The following example enables the DHCP relay feature on the device.
switchxxxxxx(config)# ip dhcp relay enable