Cisco Sx350

Rate Limit and Storm Control Commands
1007 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
50
50.5 show rate-limit interface
To display rate limit configuration on an interface, use the show rate-limit interface
command in Privileged EXEC mode.
Syntax
show rate-limit interface [ interface-id ]
Parameters
• interface-id —(Optional) Specifies an Ethernet port. If the argument is not
configured rate limit configuration of all Ethernet ports is displayed.
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Examples
The following is an example of the output from the show rate-limit interface:
switchxxxxxx> show rate-limit interface
50.6 show rate-limit vlan
To display rate limit configuration on a VLAN, use the show rate-limit vlan
command in Privileged EXEC mode.
Interface
------------
gi11gi12
Rate Limit (kbps)
----------------------
-
80000
100000
Burst (Bytes)
----------------
-
512
1024