Radius Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 998
49
Number of sent Accounting-Responses: 0
Number of incoming malformed Accounting-Requests: 0
Number of incoming Accounting-Requests with Bad Authenticator: 0
Number of incoming Accounting packets with other mistakes: 0
Number of incoming not recorded Accounting-Requests: 0
Number of incoming Accounting packets of unknown type: 0
49.21 show radius server user
To display a Radius Server user configuration, use the show radius server user
command in Privileged EXEC mode.
Syntax
show radius server user [username
user-name
] | [group
group-name
]
Parameters
•
user-name
—Specifies the user name. (Length: 1–32 characters)
•
group-name
—Specifies a name of the group. (Length: 1–32 characters)
Command Mode
Privileged EXEC mode
User Guidelines
Use the show radius server user username
user-name
command, to display one
user.
Use the show radius server user group
group-name
command, to display all users
of the given group.
Use the show radius server user command, to display all users.
Examples
The following example displays one user bob:
switchxxxxxx#
show radius server user username bob
User bob
To Next Page
Loading...
