EasyManuals Logo
Home>Cisco>Switch>Sx350

Cisco Sx350 User Manual

Cisco Sx350
1323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #689 background imageLoading...
Page #689 background image
IPv6 First Hop Security
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 688
29
Command Mode
Neighbor Binding Policy Configuration mode.
User Guidelines
If this command is part of a policy attached to a VLAN, it is applied to all the ports
in the VLAN. If it is defined in a policy attached to a port in the VLAN, this value
overrides the value in the policy attached to the VLAN.
Examples
Example 1—The following example defines an Neighbor Binding policy named
policy1, places the router in Neighbor Binding Policy Configuration mode, and
limits the number of IPv6 addresses allowed on the port to 25:
switchxxxxxx(config)#
ipv6 neighbor binding policy
policy1
switchxxxxxx(config-nbr-binding)#
max-entries interface-limit
25
switchxxxxxx(config)#
exit
Example 2—The following example defines an RA Guard policy named policy1,
places the switch in RA Guard Policy Configuration mode, and disables limit per
MAC:
switchxxxxxx(config)#
ipv6 nd raguard policy
policy1
switchxxxxxx(config-ra-guard)#
max-entries mac-limit disable
switchxxxxxx(config-ra-guard)#
exit
29.60 other-config-flag
To enable the verification of the advertised the Other Configuration flag in RA
messages within an IPv6 RA Guard policy, use the other-config-flag command in
RA Guard Policy Configuration mode. To return to the default, use the no form of
this command.
Syntax
other-config-flag {on | off
| disable}
no other-config-flag

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Sx350 and is the answer not in the manual?

Cisco Sx350 Specifications

General IconGeneral
BrandCisco
ModelSx350
CategorySwitch
LanguageEnglish

Related product manuals