Cisco Sx350 User Manual

IPv6 IPM Router Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 724
30
(2001:0DB8:999::99, FF07::1), 00:02:06/00:01:23
Incoming interface: vlan5
Outgoing interface list:
vlan40, 00:02:06/00:03:27
30.4 show ipv6 multicast
To display general information about IPv6 Multicast configuration, use the show
ipv6 multicast command in user EXEC or privileged EXEC mode.
Syntax
show ipv6 multicast [interface [ interface-id ]]
Parameters
• interface—Displays IPv6 Multicast-related information about interfaces
configured for IPv6 Multicast.
• interface-id —Interface identifier for which to display IPv6 Multicast
information.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
Use the show ipv6 multicast command without the interface keyword to display
general information about the state of IPv6 Multicast on the router.
Use the show ipv6 multicast command with the interface keyword to display the
IPv6 Multicast information about the specified interface.
Examples
Example 1. The following is sample output from the show ipv6 multicast command
without the interface keyword when no IPv6 Multicast Routing protocol is enabled:
switchxxxxxx# show ipv6 multicast

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English