Cisco Sx350

Smartport Commands
1067 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
55
Default Configuration
None
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
When a Smartport macro fails at an interface, the Smartport type of the interface
becomes Unknown. You must diagnose the reason for the failure on the interface
and/or Smartport macro, and correct the error. Before you or Auto Smartport are
allowed to reapply the desired Smartport macro, you must reset the interface
using the macro auto built-in parameters command, which changes the Smartport
type of the interface to default.
Example
Changes the Smartport type from unknown to default and resumes the Smartport
feature on port 1.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# macro auto resume
55.8 macro auto smartport (Interface)
The macro auto smartport Interface Configuration mode command enables the
Auto Smartport feature on a given interface. The no format of the command
disables the feature on the interface.
Syntax
macro auto smartport
no macro auto smartport
Parameters
This command has no parameters or keywords.
Default Configuration
Enabled.