Cisco Sx350

ACL Commands
71 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
2
2.13 absolute
Use the absolute Time-range Configuration mode command to specify an
absolute time when a time range is in effect. Use the no form of this command to
remove the time limitation.
Syntax
absolute
start hh:mm day month year
no absolute start
absolute end hh:mm day month year
no absolute end
Parameters
• start—Absolute time and date that the permit or deny statement of the
associated function going into effect. If no start time and date are specified,
the function is in effect immediately.
• end—Absolute time and date that the permit or deny statement of the
associated function is no longer in effect. If no end time and date are
specified, the function is in effect indefinitely.
• hh:mm—Time in hours (military format) and minutes (Range: 0–23, mm: 0–5)
• day—Day (by date) in the month. (Range: 1–31)
• month—Month (first three letters by name). (Range: Jan...Dec)
• year—Year (no abbreviation) (Range: 2000–2097)
Default Configuration
There is no absolute time when the time range is in effect.
Command Mode
Time-range Configuration mode
Example
switchxxxxxx(config)# time-range http-allowed
switchxxxxxx(config-time-range)# absolute start 12:00 1 jan 2005