Radius Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 988
49
Example
The following example creates a new user with name bob of group developer with
password Aerv#136dSsT:
switchxxxxxx(config)#
radius server user username bob group developers
password Aerv#136dSsT
49.15 show radius server accounting
To display user accounting information, use the show radius server accounting
command in Privileged EXEC mode.
Syntax
show radius server accounting [username
user-name
]
Parameters
•
user-name
—Specifies the user name. (Length: 1–32 characters)
Command Mode
Privileged EXEC mode
User Guidelines
The Radius server saves the last 1000 accounting logs in a cycle file on FLASH.
Use the show radius server accounting username
user-name
command, to display
accounting information of one user.
Use the show radius server accounting command, to display accounting
information of all users.
Examples
Example 1. The following example displays accounting information of all users:
switchxxxxxx#
show radius server accounting
29-Jun-14, 16:00, Stop
User: Bob
To Next Page
Loading...
Need help?
General
