Cisco Sx350

Power over Ethernet (PoE) Commands
895 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
45
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example sets the inline power management priority of
port gi1 4 to
High.
switchxxxxxx(config)# interface gi1 4
switchxxxxxx(config-if)# power inline priority high
45.6 power inline usage-threshold
To configure the threshold for initiating inline power usage alarms, use the power
inline usage-threshold Global Configuration mode command. To restore the
default configuration, use the no form of this command.
Syntax
power inline usage-threshold
percent
no power inline usage-threshold
Parameters
percent—Specifies the threshold in percent to compare to the measured power.
(Range: 1–99)
Default Configuration
The default threshold is 95 percent.
Command Mode
Global Configuration mode
Example
The following example configures the threshold for initiating inline power usage
alarms to 90 percent.
switchxxxxxx(config)# power inline usage-threshold 90