Cisco Sx350

3
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 81
802.1X Commands
3.0
3.1 aaa authentication dot1x
To specify which servers are used for authentication when 802.1X authentication
is enabled, use the aaa authentication dot1x command in Global Configuration
mode. To restore the default configuration, use the no form of this command.
Syntax
aaa authentication dot1x default {radius | none | {radius none}}
no aaa authentication dot1x default
Parameters
• radius - Uses the list of all RADIUS servers for authentication
• none - Uses no authentication
Default Configuration
RADIUS server.
Command Mode
Global Configuration mode
User Guidelines
You can select either authentication by a RADIUS server, no authentication (none),
or both methods.
If you require that authentication succeeds even if no RADIUS server response
was received, specify none as the final method in the command line.