Cisco Sx350

Management ACL Commands
821 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
39
39.5 show management access-list
To display management access lists (ACLs), use the show management
access-list Privileged EXEC mode command.
Syntax
show management access-list [
name ]
Parameters
name—(Optional) Specifies the name of a management access list to be
displayed. (Length: 1–32 characters)
Default Configuration
All management ACLs are displayed.
Command Mode
Privileged EXEC mode
Example
The following example displays the mlist management ACL.
switchxxxxxx# show management access-list mlist
m1
--
deny service telnet
permit gi11 service telnet
! (Note: all other access implicitly denied)
console(config-macl)#
39.6 show management access-class
To display information about the active management access list (ACLs), use the
show management access-class Privileged EXEC mode command.