Cisco Sx350

DHCP Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 292
12
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Default Configuration
Enabled.
User Guidelines
If the feature is enabled then the DHCP server returns
an IP address defined on the input
interface as a default router when an default router is not configured in the following case:
 Default router is not configurable.
 DHCP client is directly connected.
 IP Routing is enabled.
 Default router was required by the client.
Example
The following example disable auto default router sending.
switchxxxxxx(config-dhcp)# no auto-default-router
12.4 bootfile
To specify the default boot image file name for a DHCP client, use the bootfile
command in DHCP Pool Network Configuration mode or in DHCP Pool Host
Configuration mode. To delete the boot image file name, use the no form of this
command.
Syntax
bootfile
filename
no bootfile
Parameters
• filename —Specifies the file name used as a boot image. (Length: 1–128
characters).