Cisco Sx350

IPv6 First Hop Security
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 666
29
• The rules, configured in the policy attached to the VLAN are added to the
set if they have not been added.
• The global rules are added to the set if they have not been added.
Use the no ipv6 neighbor binding attach-policy command to detach all
user-defined policies attached to the port.
Use the no ipv6 neighbor binding attach-policy
policy-name command to detach
the specific policy from the port.
Examples
Example 1—In the following example, the Neighbor Binding policy policy1 is
attached to the gi11 port:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# ipv6 neighbor binding attach-policy policy1
switchxxxxxx(config-if)# exit
Example 2—In the following example, the Neighbor Binding policy policy1 is
attached to the gi11 port and applied to VLANs 1-10 and 12-20:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# ipv6 neighbor binding attach-policy policy1 vlan
1-10,12-20
switchxxxxxx(config-if)# exit
Example 3—In the following example, the Neighbor Binding policy policy1 is
attached to the gi11 port and applied to VLANs 1-10, and the Neighbor Binding
policy policy2 is attached to the gi11 port and applied to VLANs 12-20:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# ipv6 neighbor binding attach-policy policy1 vlan 1-10
switchxxxxxx(config-if)# ipv6 neighbor binding attach-policy policy2 vlan
12-20
switchxxxxxx(config-if)# exit