Cisco Sx350

CDP Commands
209 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
8
Syntax
cdp appliance-tlv enable
no cdp appliance-tlv enable
Parameters
N/A
Default Configuration
Enabled
Command Mode
Global Configuration mode
User Guidelines
This MIB specifies the Voice Vlan ID (VVID) to which this port belongs:
• 0—The CDP packets transmitting through this port contain Appliance
VLAN-ID TLV with value of 0. VoIP and related packets are expected to be
sent and received with VLAN-ID=0 and an 802.1p priority.
• 1..4094—The CDP packets transmitting through this port contain Appliance
VLAN-ID TLV with N. VoIP and related packets are expected to be sent and
received with VLAN-ID=N and an 802.1p priority.
• 4095—The CDP packets transmitting through this port contain Appliance
VLAN-ID TLV with value of 4095. VoIP and related packets are expected to
be sent and received untagged without an 802.1p priority.
• 4096—The CDP packets transmitting through this port do not include
Appliance VLAN-ID TLV; or, if the VVID is not supported on the port, this MIB
object will not be configurable and will return 4096.
Example
switchxxxxxx(config)# cdp appliance-tlv enable