Cisco Sx350

Ethernet Configuration Commands
413 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
17
• tx —shows sent counters statistics.
• frames —show received counters statistics collected per packet size.
Default Configuration
Display monitored statistics for an interface or all interface in case of sshow
switchport monitor
utilization command.
Command Mode
Privileged EXEC mode
User Guidelines
The show switchport monitor
utilization is used to show a utilization summary per
interface of the last time frame in each time frame(i.e. last minute, last hour, last day
and last week).
The show switchport monitor
interface-id is used to show monitored statistics
samples collected per time frame and per counter types.
Examples
Example 1—The following example displays monitored statistics utilization seen
by interface
gi11 .
switchxxxxxx# show switchport monitor utilization gi11
Example 2—The following example displays monitored Tx statistics gathered in
minutes time frame seen by interface
gi11 .
Interface
---------
gi11
Minutes Rx/TX
utilization
------------
95%
Hours Rx/TX
utilization
-----------
80%
Days Rx/TX
utilization
-----------
60%
Weeks Rx/TX
utilization
-----------
20%