Cisco Sx350

Address Table Commands
159 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
show bridge multicast address-table [vlan vlan-id ] [address
ipv6-multicast-address
] [source ipv6-source-address ]
Parameters
• vlan-id vlan-id —(Optional) Display entries for specified VLAN ID.
• address—(Optional) Display entries for specified Multicast address. The
possible values are:
- mac-multicast-address—(Optional) Specifies the MAC Multicast
address.
- ipv4-multicast-address—(Optional) Specifies the IPv4 Multicast
address.
- ipv6-multicast-address—(Optional) Specifies the IPv6 Multicast
address.
• format—(Optional) Applies if mac-multicast-address was selected. In this
case either MAC or IP format can be displayed. Display entries for specified
Multicast address format. The possible values are:
- ip—Specifies that the Multicast address is an IP address.
- mac—Specifies that the Multicast address is a MAC address.
• source —(Optional) Specifies the source address. The possible values are:
- ipv4-address—(Optional) Specifies the source IPv4 address.
- ipv6-address—(Optional) Specifies the source IPv6 address.
Default Configuration
If the format is not specified, it defaults to mac (only if mac-multicast-address was
entered).
If VLAN ID is not entered, entries for all VLANs are displayed.
If MAC or IP address is not supplied, entries for all addresses are displayed.
Command Mode
Privileged EXEC mode