Cisco Sx350

Remote Network Monitoring (RMON) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1016
51
Syntax
rmon event
index {none | log | trap | log-trap} [community text] [description text]
[owner name]
no rmon event index
Parameters
• index—Specifies the event index. (Range: 1–65535)
• none— Specifies that no notification is generated by the device for this
event.
• log—Specifies that a notification entry is generated in the log table by the
device for this event.
• trap—Specifies that an SNMP trap is sent to one or more management
stations by the device for this event.
• log-trap—Specifies that an entry is generated in the log table and an SNMP
trap is sent to one or more management stations by the device for this
event.
• community text—(Optional) Specifies the SNMP community (password)
used when an SNMP trap is sent. (Octet string;
length: 0–127 characters). Note this must be a community used in the
definition of an SNMP host using the “snmp-server host” command.
• description text—(Optional) Specifies a comment describing this event.
(Length: 0–127 characters)
• owner name—(Optional) Specifies the name of the person who configured
this event. (Valid string)
Default Configuration
If the owner name is not specified, it defaults to an empty string.
Command Mode
Global Configuration mode
Example
The following example configures an event identified as index 10, for which the
device generates a notification in the log table.