Cisco Sx350

Router Resources Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1030
52
IPv6 policy Entries 0 12 12
Non-IP Entries:
- Unit 1 93% 400
- Unit 2 94% 400
- Unit 5 90% 400
Setting the new configuration of route entries requires saving the
running-configuration file to startup-configuration file and rebooting the
system, do you want to continue? (Y/N) [N] Y
Example 2
The following example defines the supported number of IPv4 and IPv6 routing
entries. In the example, the configured router entries are less than the router
entries which are currently in use. Using this configurations means that the system
will not have enough resources for the running again in the existing network:
switchxxxxxx(config)# system router resources ip-entries 128 ipv6-entries 32
The maximal number of IPv4 Routing entries and IPv6 Routing Entries is 3072. The
number is Non-IP Entries is 3096.
In-Use Reserved (Current) Reserved (New)
------ ------------------ --------------
IPv4 Entries 232 1024 128
Number of Routes 20
Number of Neighbors 12
Number of Interfaces 100
IPv6 Entries 1024 1024 32
Number of Routes 20
Number of Neighbors 12
Number of Interfaces 100
Number of On-Link Prefixes 1
IPv4 Multicast Entries 12 1024 1024
Number of Multicast Routes 6
IPv6 Multicast 40 1024 1024
Number of Multicast Routes 5