Cisco Sx350

Smartport Commands
1069 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
55
User Guidelines
A static type set by the command cannot be changed by a dynamic type.
Example
This example shows an attempt to set the Smartport type of port 1 to printer
(statically). The macro fails at line 10. The show parser macro command is run to
display the contents of the macro printer in order to see which line failed.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# macro auto smartport type printer
30-May-2011 15:02:45 %AUTOSMARTPORT-E-FAILEDMACRO: Macro printer for auto smar
port type Printer on interface gi11 failed at command number 10
switchxxxxxx(config-if)# exit
switchxxxxxx(config)# do show parser macro name printer
Macro name : printer
Macro type : default interface
1. #macro description printer
2. #macro keywords $native_vlan
3. #
4. #macro key description: $native_vlan: The untag VLAN which will be configu
red on the port
5. #Default Values are
6. #$native_vlan = Default VLAN
7. #
8. #the port type cannot be detected automatically
9. #
10. switchport mode access
11. switchport access vlan $native_vlan
12. #
13. #single host
14. port security max 1
15. port security mode max-addresses