SPAN and RSPAN Commands
1097 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
57
Syntax
show monitor session [
session_number
]
Parameters
•
session_number
—Specify the session number identified with the SPAN or
RSPAN session. The range is 1 to 7. If the argument is not defined
information about all sessions are displayed.
Default Configuration
This command has no default settings.
Command Mode
User EXEC mode
User Guidelines
Use the show monitor session
session_number
command to display information
about one session.
Use the show monitor session command to display information about all sessions
Example
Example 1. The following example displays information about all SPAN sessions
defined into the switch:
switchxxxxxx> show monitor session
Session 1
Type: SPAN
Source: gi12
, rx only
Source: VLAN 100
Source: flow mirrow, policy-map: alpha class-maps: ip-http, ipv6-http
Destination: gi11, network port
To Next Page
Loading...
