Cisco Sx350

Virtual Local Area Network (VLAN) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1294
67
Default Configuration
The Prohibit Internal usage VLAN list is empty.
Command Mode
Global Configuration mode
User Guidelines
The switch requires an internal VLAN in the following cases:
• One VLAN for each IP interface is defined directly on an Ethernet port or on
a Port channel.
• One VLAN for each IPv6 tunnel.
• One VLAN for 802.1x.
When a switch needs an internal VLAN it takes a free VLAN with the highest VLAN
ID.
Use the vlan prohibit-internal-usage command to define a list of VLANs that cannot
be used as internal VLANs after reload.
If a VLAN was chosen by the software for internal usage, but you want to use that
VLAN for a static or dynamic VLAN, do one of the following
• Add the VLAN to the Prohibited User Reserved VLAN list.
• Copy the Running Configuration file to the Startup Configuration file
• Reload the switch
• Create the VLAN
Examples
Example 1—The following example specifies that VLANs 4010, 4012, and
4090-4094 cannot be used as internal VLANs:
vlan prohibit-internal-usage add 4010,4012,4090-4094
Example 2—The following specifies that all VLANs except 4000-4107 cannot be
used as internal VLANs:
vlan prohibit-internal-usage all