Cisco Sx350

CDP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 226
8
Power drawn: 6.300 Watts
switchxxxxxx# show cdp neighbors secondary
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
Local Interface gi11, MAC Address: 00:00:01:23:86:9c
TimeToLive: 157
Capabilities: R S
VLAN-ID: 10
Platform: 206VXRYC
Local Interface gi11, MAC Address: 00:00:01:53:86:9c
TimeToLive: 163
Capabilities: R S
VLAN-ID: 10
Platform: ABCD-VSD
Power Available TLV: Request-ID is 1
Power management-ID is 1;
Available-Power is 15.4;
Management-Power-Level is 0xFFFFFFFF
Local Interface gi12, MAC Address: 00:00:01:2b:86:9c
TimeToLive: 140
Capabilities: R S
VLAN-ID: 1210
Platform: QACSZ
4-wire Power-via-MDI (UPOE) TLV:
4-pair PoE Supported: Yes
Spare pair Detection/Classification required: Yes
PD Spare Pair Desired State: Disabled
PSE Spare Pair Operational State: Disabled