DHCP Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 320
12
Syntax
time-server
ip-address
[
ip-address2
...
ip-address8
]
no time-server
Parameters
•
ip-address
[
ip-address2
...
ip-address8
]—Specifies the IP addresses of
Time servers. Up to eight addresses can be specified in one command line.
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Default Configuration
No time server is defined.
User Guidelines
The time server’s IP address should be on the same subnet as the client subnet.
Example
The following example specifies 10.12.1.99 as the time server IP address.
switchxxxxxx(config-dhcp)#
time-server 10.12.1.99
To Next Page
Loading...
